If it is necessary to change the SSD Drive on an Acrobat Terminal with a 2 line customer display, this video shows you how.
Link to video to send to clients: https://vimeo.com/379338519/6fe5ab6936
Transcript (To aid in searching/indexing):
1
00:00:00,066 --> 00:00:03,599
To start the hard drive swap grab a Phillips head screwdriver,
2
00:00:03,600 --> 00:00:07,533
because the screws are small, make it a smaller head screwdriver.
3
00:00:07,533 --> 00:00:09,833
Also locate the hard drive that’s going in,
4
00:00:09,833 --> 00:00:14,299
Please pay attention to the labelling because drives are prepared for specific terminals
5
00:00:14,300 --> 00:00:17,133
in your location and you don’t want to mix them up.
6
00:00:17,133 --> 00:00:19,333
Then power down the terminal.
7
00:00:21,533 --> 00:00:23,433
And Flip it over.
8
00:00:30,133 --> 00:00:34,833
Carefully adjust the base so you can get access to the cover and screws.
9
00:00:36,400 --> 00:00:40,000
Then Unscrew the 2 screws.
10
00:01:13,133 --> 00:01:16,199
Remove the display.
11
00:01:21,333 --> 00:01:25,599
Carefully pull the plastic tab to guide the drive out of the terminal.
12
00:01:28,533 --> 00:01:33,399
Then carefully slide in the new drive with the label facing out as shown here.
13
00:01:36,600 --> 00:01:41,166
Paying attention to the tab on the display, snap the display back into place.
14
00:01:41,166 --> 00:01:43,932
Then don’t forget to put the 2 screws back.
15
00:01:52,733 --> 00:01:57,799
And you’re all set, ready to reconnect and power your terminal back on.
Comments